Features of the RF-BLOK shielded design:

• Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
• Increased insulation resistance up to 25%
• No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
• Tight fit of internal wires as there is no inner mould
• No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
• Smaller overall dimensions which allows more room behind the host or peripheral
• Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one

Please click here for our DVI Guide.