Easily connect a 3½” hard drive to your computers USB 2.0 or FireWire port!

• Supports up to 250GByte hard drives
• Hot-swappable connection
• External interfaces: USB 2.0 (Type B Female) & FireWire (2 x 6 Pin Female)
• Internal interface: ATA (40 Way IDC Female)
• USB 2.0 interface is backwards compatible with USB 1.1
• FireWire IEEE 1394/1394a and iLink compliant
• Stylish transparent plastic housing with silver internal coating
• Integrated low noise fan
• On/Off switch
• Silicon rubber feet protect against sliding, shock and vibration, and allow housings to be stacked one above the other
• Internal soft rubber shock absorbers provide optimum protection for the drive
• USB 2.0 cable included (Type A USB Male to Type B USB Male), 1m
• FireWire cable included (6 Pin FireWire Male to 6 Pin FireWire Male), 1m
• External power adaptor and mains cable included
• USB Chipset: ALI
• FireWire Chipset: Oxford 911, High Speed ATA version
• Supports 3½" drives with a maximum depth of 16cm
• Dimensions: 128 x 213 x 38mm (WxDxH)
• Compatible with Windows 98/ME/2000/XP and Mac OS 9.0 to 9.2 & 10 (Mac OS 10.1 or later required for USB 2.0 support)

Please click here for a guide on how to install a hard drive.

Please note: You can only make one connection from your computer to the housing via USB or FireWire. You can not connect to both the USB and FireWire ports on the housing at the same time!

To use USB housings under DOS please refer to http://www.bootdisk.com/usb.htm
Please note that LINDY is not responsible for any software and information from this link and does not support this software.