Connect Serial ATA drives to an IDE interface!

The IDE to SATA Host Bridge converter card plugs into the standard 40 Pin IDE connector on a PC motherboard and converts Parallel ATA device commands to the Serial ATA protocol, allowing you to connect up to two SATA hard drives.

• 1 x 40 Pin Female IDE connector
• 2 x Serial ATA Female connectors
• Power Connector: 3½” Type 4 Pin Male
• Supports 2 channels and 2 devices
• Supports Serial ATA Generation 1 transfer rate of 1.5Gbit/sec
• Fully compliant with Serial ATA 1.0 specifications
• Supports UDMA data transfer rates of 66, 100, 133 and 150 Mbit/sec
• Included cables: 1 x Serial ATA data cable, 1 x internal power cable
• "Plug & Play" installation

Note: The card connects vertically onto the IDE connector and requires a height clearance of up to 10cm.